Fresh skip today - wish I could have got a couple of the hydraulic accumulators out of the last one (fixed steady for the sliced-up use of), but they must have weighed a few hundred pounds each!
Today's haul took a while, the firebricks had had pallets and junk thrown on top, but I still spotted 'em!
There are mostly enough 2" insulating 1400C firebrick offcuts for a new casting furnace, I think (the last one failed to move with me...), eight 6"diameter x 6" steel rounds plus some smaller drops, a VERY rusty lapping plate and some more small steel and ally drops, a couple of machine lights (condition unknown) and most of the parts of a grinder dust-hood, and finally a nice dual power supply (0-30v 2A) with one side working to take readings from while I fix the other (completely independent) side :)
One of the 6"rounds is destined to become one or two D1-5 spindle nose replicas to drop on my rotary table to speed up fitting / centring chucks, I hope!
Rules are for the obedience of fools, and the guidance of wise men...
(Douglas Bader)
Yep, I sure do - I think we have the best skip I've ever seen, government science establishment so money no object... Did I tell you about the 4-gallon ultrasonic cleaner ;)
It does need mending, though...
Rules are for the obedience of fools, and the guidance of wise men...
(Douglas Bader)
(03-17-2015, 03:59 PM)Hopefuldave Wrote: Fresh skip today - wish I could have got a couple of the hydraulic accumulators out of the last one (fixed steady for the sliced-up use of), but they must have weighed a few hundred pounds each!
Today's haul took a while, the firebricks had had pallets and junk thrown on top, but I still spotted 'em!
There are mostly enough 2" insulating 1400C firebrick offcuts for a new casting furnace, I think (the last one failed to move with me...), eight 6"diameter x 6" steel rounds plus some smaller drops, a VERY rusty lapping plate and some more small steel and ally drops, a couple of machine lights (condition unknown) and most of the parts of a grinder dust-hood, and finally a nice dual power supply (0-30v 2A) with one side working to take readings from while I fix the other (completely independent) side :)
One of the 6"rounds is destined to become one or two D1-5 spindle nose replicas to drop on my rotary table to speed up fitting / centring chucks, I hope!
I think we have a contender for the biggest of the month!
Pipe with 12" flanges to become a fixed steady after a bit of cutting and welding, slightly rusted angle strraightedge, some drops useful for spacers / quasi-parallels and a pair of Mercer 0.0001" gauges, both in need of repair!
Excuse the state of my car boot, it's always like it...
Rules are for the obedience of fools, and the guidance of wise men...
(Douglas Bader)
Looks like the Oil Drum Furnace is getting a little closer...
Enough soft (insulating) firebrick to wrap the hard firebricks from a previous dive, plus a few hard firebricks to fill the gaps in what I've collected so far... So now I need the drum and to make a burner suitable for the 4" x 32" stainless tube! Eek!
It's amazing stuff, heat it to glowing orange with a torch, touch it half an inch away and it's cool...
Also, some sort of Brown and Sharpe tool stand, any clue what belongs in there?
Yeah, I know, 0.3 kiloLovelaces of suction...
Rules are for the obedience of fools, and the guidance of wise men...
(Douglas Bader)