11-16-2023, 07:36 PM
Very clean layout. I like it. 
Willie
|
Todays Project - What did you do today?
|
|
11-18-2023, 07:18 PM
It's alive! I'm still waiting on the sensor connector. Now UPS is saying it'll be here Tuesday instead of Monday.
 Ed
11-24-2023, 07:57 PM
I finished the mounting block for the mini lathe tachometer. I replaced the plastic mount for the chuck guard that came with the lathe with an aluminum one that has a 1/4-20 tapped hole for mounting the tachometer bracket. The cavity in the plastic block housed a micro-switch to disable the motor driver when the chuck guard was not engaged. That's one of the first things I got rid of when I first got the lathe.
Ed Original mounting block: Replacement block:
11-26-2023, 06:08 PM
Mocked up the mounting scheme for the tachometer. Looks good so I can convert it into steel.
 Ed  Thanks given by: EdK
11-27-2023, 05:55 PM
Got the magnets mounted for testing. I still need to make a holder/bracket for the Hall effect sensor.
Ed
11-28-2023, 07:18 AM
(11-26-2023, 06:08 PM)EdK Wrote: Mocked up the mounting scheme for the tachometer. Looks good so I can convert it into steel. Why bother? It's not like it will be subject to much force.
Full of ideas, but slow to produce parts
11-28-2023, 10:41 AM
(11-28-2023, 07:18 AM)rleete Wrote:(11-26-2023, 06:08 PM)EdK Wrote: Mocked up the mounting scheme for the tachometer. Looks good so I can convert it into steel. Plastic threads don't work so well, in my experience.  But, "To each his own." Ed 
11-28-2023, 11:48 AM
Any worry about the magnets flying off at high speed?
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique |
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 23 Guest(s)