Todays Project - What did you do today?
I've been working on mocking up a quill stop for the mill these past few days. Don't want to screw up the piece of 1/2" aluminum plate I bought to make it with. It's close enough now that I can tweak the arm if necessary to make it all fit together. It'll use one of those speed nuts for the adjustable stop nut.

Ed

         

   
Reply
Thanks given by:
Looks good. Graemlin
Willie
Reply
Thanks given by: EdK
I've been working on a work stop for the mill. Finally in the home stretch. I just have to make the knobs and a few finishing touches and I can cross this one off of my long list.

Ed

         
Reply
Thanks given by:
Very nice and heavy duty. You might want to think about turning down one end of your stop rod to a small diameter (long dog point) to be able to reach in between the jaws for thin parts.
Willie
Reply
Thanks given by: EdK
(09-10-2022, 07:20 PM)Highpower Wrote: Very nice and heavy duty. You might want to think about turning down one end of your stop rod to a small diameter (long dog point) to be able to reach in between the jaws for thin parts.

I plan on putting an internal thread on the end of the stop rod so I can screw in various types of tips depending on the situation.

Ed
Reply
Thanks given by:
Even better. Thumbsup
Willie
Reply
Thanks given by: EdK
I worked on making the blocks look better. Lots of chamfers followed by sanding on some fine wet/dry paper. Everything is done except for the knobs. I'm waiting on some brass rod to arrive so I can make them.
I also got the hole drilled and tapped in the end of the stop rod so it's ready for attachments. Speaking of which, I need to make some. Chin

Ed

   
Reply
Thanks given by:
Today I worked on the quill stop for the mill. I set up the HF band saw in the vertical position and attached the table to cut out the outline from the aluminum plate. It was slow going at first so I changed the speed to the fastest pulley. That didn't help much so I changed out the original blade with a replacement blade that I had bought for the saw. The original blade that came with the saw has too many teeth per inch for cutting aluminum. The new blade has a 10/14 tooth configuration. That worked much better.
Then I attacked the plate with files to roughly create the rounded features. I'll fine tune them later. It's to the point where I can mount it onto the mill table and mill the straight sides to clean them up. Then I'll start cutting the large hole that clamps over the spindle housing. I think I'll start with a hole saw and then go to the final dimension with a boring head.

Ed

   
Reply
Thanks given by:
Decided I needed a set of soft jaws for the shop vise, and I refuse to pay for them.  So, some aluminum angle, a couple of magnets and some sheet rubber.  All of which I had laying around the shop.  In fact, the rubber and angle were from the scrap bins at work, so free to me.

   


Rubber was attached to the angles with VHB tape.  Magnets were pressed in.  Total time about 30 minutes.
Full of ideas, but slow to produce parts
Reply
Thanks given by:
OMG what a mess!  Yikes

Ed

   
Reply
Thanks given by:




Users browsing this thread: 28 Guest(s)