Todays Project - What did you do today?

[RobWilson]

Knocked up a cable tie holder from a few bits of scrap 50mm x 50mm  box . 





Rob

[krv3000]

good job rob

[arvidj]

(10-24-2015, 12:35 PM)RobWilson. Wrote: Knocked up a cable tie holder from a few bits of scrap 50mm x 50mm  box . 

Rob

I thought I was doing well to have them sorted into individual ZipLoc bags, all the bags in one box and knew where the box was most of the time.

Arvid

[Kennyv]

Finally was able to do some work in the garage today. Started working on my parts for a work stop for the mill. Got most ops done  ran out of gas... To finish up all I gota do is cut slots  in all clamp block  sliders. . Cut the hardware to proper lengths. Put a finish on the parts, than modify  mill vice vice to accommodate the set up.   Was tired of using a make shift work stop figured this was 2nd worth spending the time on the new mill.

[Vinny]

Lookin good Kenny!

[Vinny]

FINALLY wired up the welder outlet yesterday. No pics, you seen one outlet hanging off the side of a breaker panel, you've seen them all.

Tonite I started up another long needed project out of that 1/2" square tubing I picked up a few months ago. Pic shows the pieces cut up, we'll see if anyone can figure out what it's going to be when it grows up. If it's not raining tomorrow I'll get it finished.



Any guesses?

[Highpower]

(10-25-2015, 09:48 PM)Vinny Wrote:

Any guesses?

Chronograph sky screen bracket?  

That's what I made mine from anyway...  

[awemawson]

My money's on a Welding Cart

[Mayhem]

My belated birthday present to me, from me 

   
   
   

Have the cable run to the board and I'll finish the wire up tomorrow, single phase 15A dedicated circuit with a combination MCB/RCD for protection.

The lights are going to get lifted and I will probably end up swapping them over to a lower profile.  My back is really going to love not having to crawl around under cars

[EdK]

Wow, that looks like a tight fit, height wise.

Ed