Todays Project - What did you do today?
Graemlin

Ed
Reply
Thanks given by:
I just hope it cures my stick-slip issue. Smiley-signs003

I know it will run more quietly now anyway. The upper bearing looked OK but the lower bearing did have moderate spalling / flaking of the inner and outer races. But since stuff flows downhill, that was to be expected even though they were both open bearings.
Willie
Reply
Thanks given by:
It looks like the factory ran a form cutter at a fast clip. Those ridges in the root were on the sides at one time. Oil pockets. Smile
Reply
Thanks given by:
The bonus of fixing my friend's bump knurler was that I used it to make some brass screws for my vise stop on my mill.

   
   
Hunting American dentists since 2015.
Reply
Thanks given by: aRM
Hey Rob! Either Darren is stealing pictures of your work, or he stole your camera.... Chin

Big Grin
Willie
Reply
Thanks given by:
(02-14-2016, 09:47 AM)Highpower Wrote: Hey Rob! Either Darren is stealing pictures of your work, or he stole your camera....   Chin

Big Grin


Narh !   he is just doing a mighty fine job  Big Grin  


Rob
Reply
Thanks given by: Mayhem
(02-14-2016, 09:47 AM)Highpower Wrote: Hey Rob! Either Darren is stealing pictures of your work, or he stole your camera.... Chin

Big Grin

Thanks for the compliment Willie Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:
You earned it.... Graemlin
Willie
Reply
Thanks given by: Mayhem
(02-14-2016, 07:27 PM)Highpower Wrote: You earned it....   Graemlin

Sure did! For a guy with no training in knurling those look perfect!
Reply
Thanks given by: Mayhem
Not todays project but one that got lots of browny points.

https://www.youtube.com/watch?v=7dNH_QjFM0w
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:




Users browsing this thread: 157 Guest(s)