Share your prints

[Highpower]

I think I have that set too. Sure would be easier to remove them from that box though than the original plastic pouch that acts like a glue trap.

[EdK]

(07-27-2024, 04:55 PM)rleete Wrote: I have that set.  Not sure they deserve a custom box.

Maybe not but they sure are easier to store that way.

Ed

[EdK]

(07-27-2024, 07:29 PM)Highpower Wrote: I think I have that set too. Sure would be easier to remove them from that box though than the original plastic pouch that acts like a glue trap.

You want one?

Ed

[Highpower]

(07-28-2024, 10:37 AM)EdK Wrote:

(07-27-2024, 07:29 PM)Highpower Wrote: I think I have that set too. Sure would be easier to remove them from that box though than the original plastic pouch that acts like a glue trap.

You want one?  

Ed

Thanks for the offer Ed but no need. It's doubtful I'll ever use them again much less repeatedly. But if I do I'll just toss them in a zip-lock bag next time.

[EdK]

I've been wanting to do this for some time now so I finally got'r done. It's a cover for my surface plate. Those marks on the top are from the glue stick that I use to hold down the item being printed.

Ed

         

[JScott]

Is that a cover for the surface plate?

[EdK]

(08-17-2024, 03:39 PM)JScott Wrote: Is that a cover for the surface plate?

Yup.

Ed

[Highpower]

Wait.... Is that an unused horizontal storage surface I see???

[EdK]

(08-17-2024, 10:02 PM)Highpower Wrote: Wait.... Is that an unused horizontal storage surface I see???

Yup, but it usually has stuff piled on it so that's why I wanted to make the cover for it.

Ed

[rleete]

I'm disappointed that you didn't put "surface plate cover" on the side. How will you know what's under there?