Share your prints
I think I have that set too. Sure would be easier to remove them from that box though than the original plastic pouch that acts like a glue trap.
Willie
Reply
Thanks given by:
(07-27-2024, 04:55 PM)rleete Wrote: I have that set.  Not sure they deserve a custom box.

Maybe not but they sure are easier to store that way.

Ed
Reply
Thanks given by:
(07-27-2024, 07:29 PM)Highpower Wrote: I think I have that set too. Sure would be easier to remove them from that box though than the original plastic pouch that acts like a glue trap.

You want one? Thumbsup

Ed
Reply
Thanks given by:
(07-28-2024, 10:37 AM)EdK Wrote:
(07-27-2024, 07:29 PM)Highpower Wrote: I think I have that set too. Sure would be easier to remove them from that box though than the original plastic pouch that acts like a glue trap.

You want one?  Thumbsup

Ed

Thanks for the offer Ed but no need. It's doubtful I'll ever use them again much less repeatedly. But if I do I'll just toss them in a zip-lock bag next time. Smile
Willie
Reply
Thanks given by: EdK
I've been wanting to do this for some time now so I finally got'r done. It's a cover for my surface plate. Those marks on the top are from the glue stick that I use to hold down the item being printed.

Ed

         
Reply
Thanks given by:
Is that a cover for the surface plate?
JScott, proud to be a member of MetalworkingFun Forum since Mar 2014.
Reply
Thanks given by:
(08-17-2024, 03:39 PM)JScott Wrote: Is that a cover for the surface plate?

Yup. Smile

Ed
Reply
Thanks given by:
Wait.... Is that an unused horizontal storage surface I see???

Jawdrop
Willie
Reply
Thanks given by:
(08-17-2024, 10:02 PM)Highpower Wrote: Wait.... Is that an unused horizontal storage surface I see???

Jawdrop

Yup, but it usually has stuff piled on it so that's why I wanted to make the cover for it. Big Grin

Ed
Reply
Thanks given by:
I'm disappointed that you didn't put "surface plate cover" on the side. How will you know what's under there?
Full of ideas, but slow to produce parts
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)