Checking My Nuts
(03-31-2015, 03:46 PM)dallen Wrote: I want to know how bad it hurt when he sawed his nut in half Thumbsup Thumbsup Thumbsup


nice looking thread

DA

Cleaning the blood off of the band saw was more painful. Big Grin

Ed
Reply
Thanks given by:
Looking great Ed, is the ground angle of the cutter off or just the cutter alignment?
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
(03-31-2015, 05:28 PM)f350ca Wrote: Looking great Ed, is the ground angle of the cutter off or just the cutter alignment?

Greg,

The ground angle of one side is off just a hair. Easy enough to fix, I think.

Ed
Reply
Thanks given by:
Is there a recommended cutting oil for bronze? I'll need all of the help I can get to cut this acme nut.

Ed
Reply
Thanks given by:
Yes....none. I worked mine dry. It cuts into tiny chips.
Reply
Thanks given by: EdK
(03-31-2015, 07:35 PM)EdK Wrote: Is there a recommended cutting oil for bronze? I'll need all of the help I can get to cut this acme nut.

Ed

While in the Navy we used white lead.  Good luck finding it.  Big Grin
Reply
Thanks given by:
That 660 bronze machines really nice Ed, you'll have no trouble with it dry. Blow the chips out between passes or better during the pass if you can.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by: EdK
Getting back to this project now. I had to reassemble the mill to take some measurements to make sure the new design for the nut assembly would fit. It does, but with little room for error. I think I've got all of the dimensions figured out and now I'm ready to make the nuts.

The nut housing will be using tapered pins to hold one of the nuts from turning just like Greg's nut. I've never used a taper pin and am wondering what size hole would you drill for the tapered reamer? The small diameter of the pin?

Ed

         
Reply
Thanks given by:
Tapered reamer drill size

Nice drawings as usual Ed.  Thumbsup
Willie
Reply
Thanks given by: EdK
Nice drawings Ed. Measure the small end of the pin itself, and drill that size. The small end of the reamer is probably smaller. You could take the holes right through, would allow chips out as you ream and room for a punch if you need to extract them.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by: EdK




Users browsing this thread: 1 Guest(s)