Latest Delivery
I've got one the same style, and pretty sure mine are also Drillpro inserts.
Only used it a couple of times when I've needed to face up to a shoulder (normally use my good facemill), but one of those times was taking a couple of mm off a real Sandvik toolholder and it worked REALLY well. Cut beautifully, and almost a mirror finish :)

Steve
Reply
Thanks given by:
This one will suit me a bit better than the Mitutoyo I have.

[Image: dro.jpg]
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:

.pdf   grinder 1.pdf (Size: 659.5 KB / Downloads: 28)

.pdf   grinder 2.pdf (Size: 303.44 KB / Downloads: 7)

.pdf   grinder 3.pdf (Size: 1.06 MB / Downloads: 8)
New to me grinder
Reply
Thanks given by:
Must be hard to use side ways like that. Was it hard to mount to the wall or haven't you done that yet?
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
I edited the pics to rotate them, but for unknown reasons they wouldn't stay.  Also had them visible instead of clicking on a link.  Also didn't stay. Smiley-signs028
Reply
Thanks given by:
Probably due to the fact that the picture files are HUGE. Try resizing them to about 1/3 of their current size. The page size shown for your pdf's is 45" X 33". Yikes
Willie
Reply
Thanks given by:
well I'm going to have to look for some different software. Bash
Reply
Thanks given by:
Stan, just lower the resolution setting on your camera so that it saves your pictures in a smaller file size. 1024 x 768 is plenty big enough for most purposes. It won't cost you a dime and you won't have to edit them for size after downloading them to your computer.

Smile
Willie
Reply
Thanks given by: Dr Stan
This articulated mount arrived today which I found on ebay. It was listed as a " Hydra Clamp ". Its cast iron and well made. I have a couple of small vises on similar bases and thought this could be modified for welding purposes. Turning in the screw hydraulically forces a piston up against the rotating ball to hold it in position. I drilled holes in a 2 1/2" C- clamp and attached it to the threaded arm. Overall, it should be a handy shop item.


Attached Files Thumbnail(s)
       
Mike
Reply
Thanks given by:
(05-14-2018, 10:13 AM)Dr Stan Wrote: well I'm going to have to look for some different software. Bash

I use GIMP. It's free and easy to use for scaling pictures.

GIMP

Ed
Reply
Thanks given by:




Users browsing this thread: 9 Guest(s)