I've got one the same style, and pretty sure mine are also Drillpro inserts.
Only used it a couple of times when I've needed to face up to a shoulder (normally use my good facemill), but one of those times was taking a couple of mm off a real Sandvik toolholder and it worked REALLY well. Cut beautifully, and almost a mirror finish :)
Probably due to the fact that the picture files are HUGE. Try resizing them to about 1/3 of their current size. The page size shown for your pdf's is 45" X 33".
Stan, just lower the resolution setting on your camera so that it saves your pictures in a smaller file size. 1024 x 768 is plenty big enough for most purposes. It won't cost you a dime and you won't have to edit them for size after downloading them to your computer.
Posts: 239
Threads: 2
Joined: Sep 2016
Location: California & Wales Home & Home Away
The following 6 users Like Mike E.'s post: JScott (05-14-2018), EdK (05-14-2018), Highpower (05-14-2018), Pete O (05-14-2018), f350ca (05-15-2018), Hopefuldave (08-18-2019)
This articulated mount arrived today which I found on ebay. It was listed as a " Hydra Clamp ". Its cast iron and well made. I have a couple of small vises on similar bases and thought this could be modified for welding purposes. Turning in the screw hydraulically forces a piston up against the rotating ball to hold it in position. I drilled holes in a 2 1/2" C- clamp and attached it to the threaded arm. Overall, it should be a handy shop item.
![[Image: dro.jpg]](http://metalshop.nobucks.net/pix/dro.jpg)
