Todays Project - What did you do today?
Smiley-signs021  nice welding job Rob.  Thumbsup

Ed
Reply
Thanks given by:
Building Christmas presents.
Julia uses and collects fountain pens so we made a storage box out of cherry. Still need to add dividers to the drawers and get a flocking kit to make a fake felt cover in them.

[Image: IMG_1990.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
Very nice!
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by: f350ca
Thanks,
Another present in the works.
Charlie is always working on a bicycle so santa is bringing him a bike work stand.
This mounts on a 2 inch vertical tube and clamps the frame.
The jaws will be lined with leather for a non marring surface, the lead screw was salvage from a car scissor jack, the claps are split cotters.
[Image: IMG_1992.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
nice work rob
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
Almost finished.

[Image: IMG_1996.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
Lookin good!
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by: f350ca
(12-21-2015, 11:03 AM)Sunset Machine Wrote: Guessing:  It looks like the end of the cutter has made full contact, causing chatter. Not enough relief, the endmill has slipped in a collet, or there's a lot of flex in the mill. The full circle here is saying something:

Well I found part of the problem....   Blush

   

   

I went ahead and tried taking a skim cut with a 1" 4-flute HSS endmill. MUCH better!   Smile

   

   

Time to get the ring off of the arbor and turn it into a broach bushing.

   

Won't be long now. (Famous last words...)   Rotfl

   

   
Willie
Reply
Thanks given by:
Nice work Willie.

Ed
Reply
Thanks given by:
Meh. No shiny cameras here I'm afraid. The ratchet pads are now .010" under size in height since I had to cut out the chatter marks from the other end mill. You can still see small ghost areas on some of them because I wanted to trim off as little as necessary to get them 'flat'. There are a few 'witness marks' that remain but the press won't care. Ten thou won't make a bit of difference to the press handle or ratchet pawl. It's like a honey badger.... Rotfl

I think the difference in material strength will more than make up for the slightly smaller dimensions of the teeth/pads.
It's just the principal of the thing - you know?

But as I said before.... I NEED the practice! Obviously. Rotfl Rotfl Rotfl
Willie
Reply
Thanks given by:




Users browsing this thread: 25 Guest(s)