Todays Project - What did you do today?
Pixman, interesting that someone would know what it was, I'd never heard of one till Charlie got into film school. No bearings, with the loads involved and polished shafts (not drill bits) brass bushings should last a long time. It will give a four to one increase, followed by about a 1 to 4 decrease to the lens, or overall 1 to 1. Will see how it feels, can either shim the gears or use a belleville washer to preload the gears. He has a Canon 5D at the moment, but hope to build the mount fairly universal.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
(02-17-2013, 05:57 PM)PixMan Wrote: Back to the shop today to touch up the sliding member of Willie's planer gauge. The camera and lighting on this photo do make the finish look a lot worse than it really is, sorry about that. There are visual grind marks, though hard to feel. A quick lapping job would make them disappear. At least now both pieces have the same finish.

[Image: IMG_1789-r_zps5b3c4f59.jpg]

Nice job Ken! That looks beautiful. I'm sure Willie is very pleased with the results.

Ed
Reply
Thanks given by:
(02-18-2013, 06:47 AM)EdK Wrote: Nice job Ken! That looks beautiful. I'm sure Darren is very pleased with the results.

Ed

Woo Hoo - looks like I just scored myself a planer gauge, thanks Ken, Ed and of course Willie.
Hunting American dentists since 2015.
Reply
Thanks given by:
Lol...Ken's gonna wonder why it cost so much to send back.
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
No - I'm sure Ken knows the postage rates off by heart now! Or he can hold on to it until I'm back in the US. I need an excuse to visit MA again.
Hunting American dentists since 2015.
Reply
Thanks given by:
Wait..... whaaaaa??? 17428
Willie
Reply
Thanks given by:
No take backs Tongue
Hunting American dentists since 2015.
Reply
Thanks given by:
(02-18-2013, 07:11 AM)Mayhem Wrote:
(02-18-2013, 06:47 AM)EdK Wrote: Nice job Ken! That looks beautiful. I'm sure Darren is very pleased with the results.

Ed

Woo Hoo - looks like I just scored myself a planer gauge, thanks Ken, Ed and of course Willie.

Oops! Open mouth, insert foot. Blush

Sorry Willie!

Ed
Reply
Thanks given by:
I was going to say... I don't think I sent Ken enough postage to get it down under. Chin

And yes - it does look bea-uti-full don't it!!!??? Tongue

And unlike the last owner, I intend to keep it that way. Big Grin
Willie
Reply
Thanks given by:
(02-18-2013, 06:23 PM)Highpower Wrote: And yes - it does look bea-uti-full don't it!!!??? Tongue

It surely does. Thumbsup
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:




Users browsing this thread: 93 Guest(s)