Floor mats
#11
i dont have any of the open mats but i would think that they would be hard on the knees if you had to kneel on one.
mikecwik, proud to be a member of MetalworkingFun Forum since Apr 2012.
Reply
Thanks given by:
#12
I gave up on using any form of matting. With soft matting the swarf just got embedded in it and was very difficult to remove, and with hard matting the swarf lay on top and stuck to my shoes..
I made some wooden duck-boards instead, they're comfortable to stand on, and the swarf just drops through.


Attached Files Thumbnail(s)
   
lemelman, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:
#13
Hi
I have tried many things
Bob (krv3000) kindly gave me this rubber mat
It is nice on the feet and seems to trap the swarf (i have major problems with swarf in the house) well i dont but the wife hasSlapheadSlaphead
[Image: P7180059.jpg]

[Image: P7180060.jpg]

Thanks again BobThumbsupThumbsupThumbsup
John
Reply
Thanks given by:
#14
no problem john
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#15
(07-18-2012, 04:18 PM)doubleboost Wrote: ...i have major problems with swarf in the house...well i dont but the wife hasSlapheadSlaphead...

Better get on top of that John or she will make you strip off in the shop and do the nudie run to the house. I can't see that being fun in a Northern winter!
Hunting American dentists since 2015.
Reply
Thanks given by:
#16
I have industrial grade mats in front of my lathe. They are smooth, not ribbed like the Costco mats so they are easy to clean and they are made of rubber, not vinyl so they are durable as heck. I've had the same mats for over 20 years and they still look good. The 2x5 size is good because they are big enough to stand on and small enough to move around when you sweep.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#17
I wonder if old conveyor belt would be 'soft' enough to provide any benefit over the concrete floor? I have a roll 5' wide down the side of the shed.
Hunting American dentists since 2015.
Reply
Thanks given by:
#18
(07-19-2012, 09:14 PM)Mayhem Wrote: I wonder if old conveyor belt would be 'soft' enough to provide any benefit over the concrete floor? I have a roll 5' wide down the side of the shed.

Conveyor belt is very dense I doubt you would realize any relief from the hard floor at all.Smiley-gen163

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: