Knackered parting tool holder
#1
Photo 
Well yesterday I ******** my Glanze parting blade holder so what to replace it with , I use the Myford rear tool holder with the parting blade upside down the Glanze holder has 8mm shank, suggestions please.

Dell
   


Attached Files Thumbnail(s)
   
Old man but still learning 
Reply
Thanks given by:
#2
I bought this one recently: https://www.ebay.com/itm/225951437627

I haven't tried it yet, so I can't comment on how well it works.
Full of ideas, but slow to produce parts
Reply
Thanks given by:
#3
(01-19-2024, 10:44 AM)rleete Wrote: I bought this one recently:  https://www.ebay.com/itm/225951437627

I haven't tried it yet, so I can't comment on how well it works.

The description for that one says it uses 2.5mm inserts but the picture shows a tool that holds 1.5mm inserts. Is the description correct or the picture?  17428

Mine uses 1.5mm inserts, I wanted the thinnest one I could get.

Ed
Reply
Thanks given by:
#4
Tool shank is .395 (10mm) square. Inserts are about .098 or 2.5mm. the blade part that holds the inserts is thinner than that, so it looks like it could hold the thinner ones.
Full of ideas, but slow to produce parts
Reply
Thanks given by: EdK
#5
I think the blade part needs to be narrower than the insert width so that the blade portion doesn't rub inside the cut. Chin
Willie
Reply
Thanks given by:
#6
That looks like the one I got from Shars on ebay. Works quite well. A few guys on the Logan list are using them too.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
#7
Just had this reply from Chronos the UK supplier for Glanze regarding my damaged parting tool holder.
My reply was if you use a rear parting tool in a lathe with screw on chuck it has to be upside down because the lathe can’t be run backwards otherwise it will unscrew the chuck.


Hi

Thanks for the email- i have not seen that happen before- Can I ask why it was used upside down???

Regards

Mark
Old man but still learning 
Reply
Thanks given by:
#8
Unfortunately that happens from time to time when you get someone that doesn't have a full understanding of their own products. I had a number of employees at a welding supply company tell me that a certain type of filler rod does not exist when they have it listed for sale on their own web site.
Willie
Reply
Thanks given by:
#9
Have bitten the bullet and purchased a Myford rear parting tool and post.
https://myford.co.uk/acatalog/REAR-TOOLP...-1559.html
Old man but still learning 
Reply
Thanks given by:
#10
Chap at Chronos gave me a refund even though I had had it for a long time although only used twice, can’t fault that.
Old man but still learning 
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)