MetalworkingFun Forum › Machining › General Metalworking Discussion v
Apprentice marks.

Thread Modes
Apprentice marks.
Highpower Offline
JAFO
******
Posts: 4,463
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
The following 3 users Like Highpower's post:
EdK (09-04-2018), f350ca (09-04-2018), JScott (09-05-2018)
#1
09-04-2018, 03:24 PM
I just got an email from my buddy that I used to work with. The subject line was one word. "Kids..."

These days he gets all the jobs they used to dump on me after an apprentice had a learning experience.    Rotfl

   
Willie
Reply
Thanks given by:
terrywerm Offline
Sophmore
***
Posts: 60
Threads: 6
Joined: Nov 2013
Location: Jordan, MN
#2
09-22-2018, 06:55 AM
Holy cow, that one is really drilled off center. Blind hole too, by the looks of it.
[Image: coffee2.gif]


Terry
Making stuff with old machines.
Reply
Thanks given by:
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#3
09-22-2018, 09:13 AM
Reminds me of repair jobs I did in the Navy after a Machinist Mate or Boiler Tech tried to play Machinery Repairman.
Reply
Thanks given by:
Mike E. Offline
Sophmore
***
Posts: 239
Threads: 2
Joined: Sep 2016
Location: California & Wales Home & Home Away
The following 1 user Likes Mike E.'s post:
Dr Stan (09-23-2018)
#4
09-22-2018, 03:05 PM (This post was last modified: 09-22-2018, 03:06 PM by Mike E.. Edit Reason: spell check )
I'd find an appropriate nut, plug weld it over the broken bolt, then spin it out. The heat transfer should break the thread bond.
Mike
Reply
Thanks given by:
Downwindtracker2 Offline
Freshman
**
Posts: 14
Threads: 3
Joined: Nov 2014
Location: Abbotsford, B.C
#5
12-02-2018, 09:47 PM
Someone hadn't shown him the easy way to do it.
Reply
Thanks given by:
Welrod Offline
Freshman
**
Posts: 30
Threads: 1
Joined: Jun 2012
Location: Belgium
The following 1 user Likes Welrod's post:
EdK (12-06-2018)
#6
12-06-2018, 02:52 PM
Hello,

https://www.facebook.com/RegiosdeHuesoCo...102354147/

Bye,
Michel
Welrod, proud to be a member of MetalworkingFun since Jun 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)