+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Apprentice marks. (/thread-3930.html)
Apprentice marks. - Highpower - 09-04-2018
I just got an email from my buddy that I used to work with. The subject line was one word. "Kids..."
These days he gets all the jobs they used to dump on me after an apprentice had a learning experience.
[attachment=15858]
RE: Apprentice marks. - terrywerm - 09-22-2018
Holy cow, that one is really drilled off center. Blind hole too, by the looks of it.
RE: Apprentice marks. - Dr Stan - 09-22-2018
Reminds me of repair jobs I did in the Navy after a Machinist Mate or Boiler Tech tried to play Machinery Repairman.
RE: Apprentice marks. - Mike E. - 09-22-2018
I'd find an appropriate nut, plug weld it over the broken bolt, then spin it out. The heat transfer should break the thread bond.
RE: Apprentice marks. - Downwindtracker2 - 12-02-2018
Someone hadn't shown him the easy way to do it.
RE: Apprentice marks. - Welrod - 12-06-2018
Hello,
https://www.facebook.com/RegiosdeHuesoColorado/videos/580608102354147/
Bye,
Michel