MetalworkingFun Forum › Machining › General Metalworking Discussion v
HHIP 3901-5032 ER-32 Collet Chuck

Thread Modes
HHIP 3901-5032 ER-32 Collet Chuck
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#1
11-25-2016, 03:32 PM (This post was last modified: 11-25-2016, 03:34 PM by chucketn.)
Anyone know if the body of this collet chuck on Amazon.com is hardened? I would want to add tommy bar holes.
https://www.amazon.com/HHIP-3901-5032-ER...B01ADK2PM2

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:
EdK Offline
Whipping Boy
*******
Posts: 8,854
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
#2
11-25-2016, 06:02 PM
I'm guessing since the surfaces appear to be ground, it must be hardened to some degree. I posed the question to the distributor and will let you know what they say, if anything.

Ed
Reply
Thanks given by:
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#3
11-25-2016, 06:45 PM
Thanks, Ed. I tried to find a way to ask that question on Amazon, but didn't find anything.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:
EdK Offline
Whipping Boy
*******
Posts: 8,854
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
#4
11-25-2016, 07:02 PM
Yea, I went to HHIP's web site and asked the question. I'm not expecting an answer I would trust but we'll see what they say, if anything.

Ed
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)