+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: HHIP 3901-5032 ER-32 Collet Chuck (/thread-3395.html)
HHIP 3901-5032 ER-32 Collet Chuck - chucketn - 11-25-2016
Anyone know if the body of this collet chuck on Amazon.com is hardened? I would want to add tommy bar holes.
https://www.amazon.com/HHIP-3901-5032-ER-32-Collet-Diameter/dp/B01ADK2PM2
Chuck
RE: HHIP 3901-5032 ER-32 Collet Chuck - EdK - 11-25-2016
I'm guessing since the surfaces appear to be ground, it must be hardened to some degree. I posed the question to the distributor and will let you know what they say, if anything.
Ed
RE: HHIP 3901-5032 ER-32 Collet Chuck - chucketn - 11-25-2016
Thanks, Ed. I tried to find a way to ask that question on Amazon, but didn't find anything.
Chuck
RE: HHIP 3901-5032 ER-32 Collet Chuck - EdK - 11-25-2016
Yea, I went to HHIP's web site and asked the question. I'm not expecting an answer I would trust but we'll see what they say, if anything.
Ed