CCMT Tool Holder

[Dr Stan]

try here:  http://www.travers.com/sclc-r-l-toolhold...50%22%20SQ

[EdK]

(07-07-2015, 05:08 PM)Dr Stan Wrote: try here:  http://www.travers.com/sclc-r-l-toolhold...50%22%20SQ

That doesn't use the 100 degree corners. That's just a standard tool for CCMT inserts.

Ed

[the penguin]

(07-07-2015, 05:12 PM)EdK Wrote:

(07-07-2015, 05:08 PM)Dr Stan Wrote: try here:  http://www.travers.com/sclc-r-l-toolhold...50%22%20SQ

That doesn't use the 100 degree corners. That's just a standard tool for CCMT inserts.

Ed

The SECO unit is the only one I found that uses the 100 degree corner, there are probably others

the SCRCR use the 100 degree point, the commonly available SCLCR uses the 80 degree point.

[svk]

Can you use these?
http://www.greenwood-tools.co.uk/shopscr45.html

[EdK]

(07-09-2015, 10:56 PM)svk Wrote: Can you use these?
http://www.greenwood-tools.co.uk/shopscr45.html

That would work but shipping would be prohibitive. Thanks for posting the link though. Someone over on that side of the pond may find it useful.

Ed