CCMT Tool Holder

[EdK]

Does anyone know of a source for a CCMT tool holder that can make use of the 100 degree corners for 32.XX sized inserts? I have one for the smaller 21.XX inserts but haven't found one for the larger inserts.

Ed

[Mayhem]

Have a look at the ToolMex web site.

[EdK]

(05-02-2015, 10:14 PM)Mayhem Wrote: Have a look at the ToolMex web site.

No luck there.

Ed

[PixMan]

I've checked with Mitsubishi, NTK and Kyocera, nothing. I'm not saying someone doesn't have it, but if those three who specialize in small screw-down insert holders don't have it, you aren't going to have an easy time of it.

What's the maker and designation of the one you do have?

[EdK]

Thanks for checking Ken. The one I have is a Micro 100. They only make them for the smaller insert size though.

Ed

[Mayhem]

You've got a mill Ed...

I did check the Toolmex site and they do them for negative inserts only. I knew I had seen them there.

[EdK]

(05-03-2015, 10:43 AM)Mayhem Wrote: You've got a mill Ed...
...

Not yet.

Ed

[Mayhem]

1/2 a mill???

[Highpower]

SECO has one, but I didn't bother to register just to find out how much they cost.   

https://www.store.secotools.com/webapp/w...Term=13316

[the penguin]

(05-03-2015, 08:11 PM)Highpower Wrote: SECO has one, but I didn't bother to register just to find out how much they cost.   

https://www.store.secotools.com/webapp/w...Term=13316

$96