Big Tools Small Lathe

[doubleboost]

Hi
Lads

I have been that busy with vids I keep forgetting to post pictures
I have recently been given some lathe tools

They need machining to fit my tool holders


The pictures are "grabbed" frames from a hd video


I was also given a 6 inch mag chuck


I had a back plate to modify




All this can be seen on this sundays video
John

[dallen]

if the holders are big enough I just cut a dovetail in the side of them and put in a height adjuster screw

Nice work on the holders

DA

[doubleboost]

(08-10-2014, 04:55 PM)dallen Wrote: if the holders are big enough I just cut a dovetail in the side of them and put in a height adjuster screw

Nice work on the holders

DA

I have done the same thing
These ones went in to the tool holder nut not low enough for centre height
John

[Micktoon]

Hi John , A nice little haul there, I like that mag chuck, good to see you kept busy this afternoon , the photos look spot on for a video catch type photo too.
Good to see some normal photo posts again from you too

Cheers Mick.

[RobWilson]

Arrrh so you do remember how to do photos , aboot time inall , looks a canny mag chuck mate , nice that you have made it fit my lathe too


Rob

That reminds me Bob gave me a mag chuck ,,,,,,,,,,,,must get that mounted on the Cub lathe

[doubleboost]

(08-11-2014, 01:38 PM)RobWilson. Wrote: Arrrh so you do remember how to do photos , aboot time inall , looks a canny mag chuck mate , nice that you have made it fit my lathe too


Rob

That reminds me Bob gave me a mag chuck ,,,,,,,,,,,,must get that mounted on the Cub lathe

Any time you need it mate

[awemawson]

Mighty small doc on stuff mounted on a mag chuck in a lathe please. Once it slides even slightly it's off balance and shortly after it's off the chuck.

I've only really felt happy using them on the cylindrical grinder where the cutting forces are very small - or should be !

[doubleboost]

Hi
Lads
Did a bit more with the chuck back plate
Made some "pointy studs" to transfer the hole pattern


A gentle tap with a soft hammer




The marks have been transferred with no maths at all


Lined up with the super accurate eye ball and pointy wiggler






John

[doubleboost]

(08-11-2014, 04:00 PM)awemawson Wrote: Mighty small doc on stuff mounted on a mag chuck in a lathe please. Once it slides even slightly it's off balance and shortly after it's off the chuck.

I've only really felt happy using them on the cylindrical grinder where the cutting forces are very small - or should be !

The chuck will be used on the mill & rotary table
They have a B oxford spindle thread
I can picture things flying off the chuck
John

[awemawson]

Oh good :)