|
Project Spin Indexer Tailstock
|
08-29-2014, 04:59 PM
Got another part almost done but I ran out of time. I'll finish it up tomorrow.
The surface finish sucks so no shiny metal camera shot this time. I haven't figured out how to get a decent finish on O-1 tool steel.  Ed
08-30-2014, 11:17 AM
Got this piece done.
Ed
08-30-2014, 01:44 PM
 Ed Every part made is a step closer to the finish line , nice bit of screw cutting  Rob Thanks given by: EdK
08-30-2014, 01:58 PM
Looking good!
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Thanks given by: EdK
08-30-2014, 08:04 PM
Is that the piece in the drawing in you preceding post Ed?
Hunting American dentists since 2015.
08-31-2014, 06:08 AM
Nicely done Ed,
 DaveH Thanks given by: EdK
08-31-2014, 11:09 AM
(08-30-2014, 08:04 PM)Mayhem Wrote: Is that the piece in the drawing in you preceding post Ed? Yes, and I know what you're thinking. The drawing shows a step down dimension in the area where the hole is drilled. I copied the original drawing from the article but once I got to the point of cutting it I decided it wasn't necessary and is stronger without the step. A handle goes into that hole and is used for clamping the arbor. Oh, and I did change the drawing to remove the step.  Ed
That's the way I do it Ed. I work to the drawing and then when I'm done I revise the drawing to resemble the part I've made .
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
08-31-2014, 04:00 PM
08-31-2014, 04:59 PM
(08-31-2014, 02:41 PM)stevec Wrote: That's the way I do it Ed. I work to the drawing and then when I'm done I revise the drawing to resemble the part I've made . Actually, this time it was a conscious design decision and not an oops! design change. That's usually not how it works for me most times though.  Ed |
|
« Next Oldest | Next Newest »
|
