06-10-2013, 05:07 PM
(This post was last modified: 06-10-2013, 05:43 PM by the penguin.)
The day has been hard, between watching/doing the OSHA 10 hour safety course on line and the madding search for a certain threading tool, today had been real bad.
The OSHA course is down right boring, almost to the point of praying for a heart attack or some other serious ailment , so I wouldn't have to continue.
The search for a MTVOR 10-3B lathe tool was down right frustrating. I was given a healthy supply of stand-on-edge inserts (TNMC 32 NV) for nothing, so all I needed was the tool. I called about 4 manufacturers, which led me to 6 distributors, then to numerous retail units all to no avail. Usual responses were, 3-4 weeks, we don't sell to individuals, and the "best" was 2 day delivery at $145. I finally found the tool, sitting in a warehouse in Salt Lake City. The supplier (outside of Phoenix, AZ) will have it to me by Thursday, it free shipping and handling, my cost of about $62 for the piece made by Dorian.
The OSHA course is down right boring, almost to the point of praying for a heart attack or some other serious ailment , so I wouldn't have to continue.
The search for a MTVOR 10-3B lathe tool was down right frustrating. I was given a healthy supply of stand-on-edge inserts (TNMC 32 NV) for nothing, so all I needed was the tool. I called about 4 manufacturers, which led me to 6 distributors, then to numerous retail units all to no avail. Usual responses were, 3-4 weeks, we don't sell to individuals, and the "best" was 2 day delivery at $145. I finally found the tool, sitting in a warehouse in Salt Lake City. The supplier (outside of Phoenix, AZ) will have it to me by Thursday, it free shipping and handling, my cost of about $62 for the piece made by Dorian.
jack
