SloMo Wobbler
#1
Video 
A small ocsilating engine in slow motion






Just as a bit of info. It is running at about 700rpm, about 12 revs/second.


The real time length of the video clip is about 0.9 sec, if you count the revolutions it should be about 10 or 11.


Now wasn't that bluudy exciting Big GrinBig GrinBig Grin
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#2
(02-28-2012, 01:41 PM)DaveH Wrote: A small ocsilating engine in slow motion






Just as a bit of info. It is running at about 700rpm, about 12 revs/second.


The real time length of the video clip is about 0.9 sec, if you count the revolutions it should be about 10 or 11.


Now wasn't that bluudy exciting Big GrinBig GrinBig Grin
Smiley-eatdrink004
DaveH

VERY NICE tom

Logan 10x26" lathe
SIEG 12x40" lathe
RongFU 45 clone mill
6" import band saw
Baldor Grinder
thousand of tools+tooling pieces 40 yrs of collecting
Reply
Thanks given by:
#3
Dave,

I assume you made that, is that correct?

Nice little engine that runs very nice. Smiley-signs107

Ed
Reply
Thanks given by:
#4
Thanks Tom

Thanks Ed,

I made it all on a Sherline lathe and mill, I'm a bit of a fan of Sherline stuffSmileSmileSmile
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#5
(02-28-2012, 04:10 PM)DaveH Wrote: I made it all on a Sherline lathe and mill, I'm a bit of a fan of Sherline stuffSmileSmileSmile
Smiley-eatdrink004
DaveH

Just goes to show you that size doesn't matter as long as it's a well made tool like a Sherline.

Ed
Reply
Thanks given by:
#6
Just some pics.

On the Sherline cutting the fly wheel
   

   
Straight off the mill - still needs a bit of cleaning up
   

Shows the size
   

After a bit of spit and polish
   

Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#7
I never get tired of that little clip!Smiley-signs107

Dave how long to make something like that?

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#8
Dave,

Did you make that angle plate that the 3-jaw chuck is mounted on?

Ed
Reply
Thanks given by:
#9
(03-02-2012, 07:22 AM)EdAK Wrote: Dave,

Did you make that angle plate that the 3-jaw chuck is mounted on?

Ed
Hi Ed,

Yes I did, what I'll do is take some pics and start a new thread.
Smiley-eatdrink004
DaveH

Reply
Thanks given by:
#10
Good idea Dave. Idea
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)