09-25-2016, 08:13 AM
Do you mean roll it 3.5 radius? bending in break terms means to fold, rolling means to form a circle
Anthony.
Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
|
Bending Question
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Bending Question - by Rainman1 - 09-25-2016, 07:05 AM
RE: Bending Question - by pepi - 09-25-2016, 07:28 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 07:51 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 07:57 AM
RE: Bending Question - by ieezitin - 09-25-2016, 08:13 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 08:32 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 08:34 AM
RE: Bending Question - by dallen - 09-25-2016, 10:13 AM
RE: Bending Question - by ieezitin - 09-25-2016, 07:34 PM
RE: Bending Question - by aametalmaster - 09-25-2016, 08:38 PM
RE: Bending Question - by PixMan - 09-26-2016, 08:01 PM
RE: Bending Question - by Dr Stan - 09-26-2016, 10:58 PM
|
Users browsing this thread: 3 Guest(s)