Ball turner tool geometry
#6
The way I set my ball turner to cut a specific diameter is to make sure that you are measuring from the center of the pivot point of the ball turner. I use gauge blocks on a surface plate to set the tool.
Reply
Thanks given by:


Messages In This Thread
Ball turner tool geometry - by ieezitin - 11-09-2015, 07:15 PM
RE: Ball turner tool geometry - by EdK - 11-09-2015, 08:02 PM
RE: Ball turner tool geometry - by DaveH - 11-09-2015, 08:08 PM
RE: Ball turner tool geometry - by ieezitin - 11-09-2015, 08:21 PM
RE: Ball turner tool geometry - by Vinny - 11-09-2015, 08:24 PM
RE: Ball turner tool geometry - by loggerhogger - 11-24-2015, 11:13 PM
RE: Ball turner tool geometry - by aametalmaster - 12-05-2015, 05:49 PM



Users browsing this thread: 1 Guest(s)