cutter breakage
#11
(02-15-2015, 07:42 PM)PixMan Wrote: Chip load per tooth.

Too high = excess load and the cutter "hogs in" and breaks
Too low = rub the sharp edge dull

Sort of like "Goldilocks and the three machinists"...
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
cutter breakage - by how'sitwork? - 02-15-2015, 04:37 PM
RE: cutter breakage - by Baron - 02-15-2015, 04:43 PM
RE: cutter breakage - by DaveH - 02-15-2015, 05:28 PM
RE: cutter breakage - by Highpower - 02-15-2015, 05:52 PM
RE: cutter breakage - by PixMan - 02-15-2015, 07:42 PM
RE: cutter breakage - by Mayhem - 02-16-2015, 10:54 PM
RE: cutter breakage - by Sunset Machine - 02-16-2015, 09:40 AM
RE: cutter breakage - by how'sitwork? - 02-16-2015, 01:55 PM
RE: cutter breakage - by Highpower - 02-16-2015, 05:24 PM
RE: cutter breakage - by Vinny - 02-16-2015, 06:15 PM
RE: cutter breakage - by TomG - 02-16-2015, 09:31 PM



Users browsing this thread: 1 Guest(s)