Colchester Bantam Lathe
#2
Ian, firstly Smiley-signs046

And secondly, the only transition gear I know of would be a 127 tooth gear but I don't know what metric pitches the transitioned TPI settings would produce. Someday I may have to do the math but so far any metric threading has been done on my 16x60 which has both metric and inch pitches on its threading charts.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Colchester Bantam Lathe - by PLUTO - 02-19-2014, 05:33 AM
RE: COLCHESTER BANTAM LATHE - by stevec - 02-19-2014, 08:26 AM
RE: COLCHESTER BANTAM LATHE - by EdK - 02-19-2014, 08:40 AM
RE: COLCHESTER BANTAM LATHE - by PLUTO - 02-19-2014, 09:50 AM
RE: Colchester Bantam Lathe - by doubleboost - 02-19-2014, 05:34 PM



Users browsing this thread: 1 Guest(s)