Project Mini Lathe Mods
#11
Ready for the bolt holes and this project will be done. I think I'll just use the DRO to dimension the bolt holes since the PLA model mated up with the steel riser block perfectly. Plus it'll be a good opportunity to try out the DRO bolt hole circle function.

Ed

   
Reply
Thanks given by:
#12
Got'r done! After lunch I'm going to clean off the lathe and dismantle it and reassemble it with the new parts. I might have to shorten the screws so they're flush with the disk. I'll find out when I go to assemble it.

Ed

         
Reply
Thanks given by:
#13
That would bug me no end, even if I never disassembled it ever again.

Chuck them up in the lathe and face them off to the same length.
Full of ideas, but slow to produce parts
Reply
Thanks given by:
#14
(06-04-2024, 03:11 PM)rleete Wrote: That would bug me no end, even if I never disassembled it ever again.

Chuck them up in the lathe and face them off to the same length.

Here you go Roger. I just removed them and  filed them down. Much quicker than installing the 4-jaw chuck.  Big Grin

Ed

   
Reply
Thanks given by:
#15
All done except for the bronze gib. That's a separate project in itself. That's going to take some thinking as to how to hold it to machine the angles.  Chin

Ed

   
Reply
Thanks given by:
#16
What? You don't have a surface grinder and a Herman-Shmidt angle vise? Your tool crib is lacking...
Full of ideas, but slow to produce parts
Reply
Thanks given by:
#17
(06-04-2024, 04:56 PM)rleete Wrote: What?  You don't have a surface grinder and a Herman-Shmidt angle vise?  ...

Not yet.  Rotfl

I do want to make a lantern chuck for shortening screws. I've been studying plans I found online to come up with my own design. I've wanted to make one of those for years.

Ed
Reply
Thanks given by:
#18
Well, post the plans. It's always been on my list for #6 and smaller screws.
Full of ideas, but slow to produce parts
Reply
Thanks given by:
#19
(06-05-2024, 09:48 AM)rleete Wrote: Well, post the plans.  It's always been on my list for #6 and smaller screws.

Will do. My plan is to make it useful for 1/4" and smaller screws.

Ed
Reply
Thanks given by:
#20
Installing the AXA tool post reduced the diameter of work that I could machine in the lathe so I'm doing the extension mod. I bought the longer length cross slide feed screw from LMS. They wanted $40 for the spacer & I'm not willing to pay that amount for a simple spacer so I'll make my own.

Ed

         
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)