CCMT Tool Holder
#11
try here:  http://www.travers.com/sclc-r-l-toolhold...50%22%20SQ
Reply
Thanks given by:
#12
(07-07-2015, 05:08 PM)Dr Stan Wrote: try here:  http://www.travers.com/sclc-r-l-toolhold...50%22%20SQ

That doesn't use the 100 degree corners. That's just a standard tool for CCMT inserts.

Ed
Reply
Thanks given by:
#13
(07-07-2015, 05:12 PM)EdK Wrote:
(07-07-2015, 05:08 PM)Dr Stan Wrote: try here:  http://www.travers.com/sclc-r-l-toolhold...50%22%20SQ

That doesn't use the 100 degree corners. That's just a standard tool for CCMT inserts.

Ed

The SECO unit is the only one I found that uses the 100 degree corner, there are probably others

the SCRCR use the 100 degree point, the commonly available SCLCR uses the 80 degree point.


Attached Files
.jpg   seco.jpg (Size: 4.15 KB / Downloads: 48)
jack
Reply
Thanks given by: EdK
#14
Can you use these?
http://www.greenwood-tools.co.uk/shopscr45.html
svk, proud to be a member of MetalworkingFun Forum since Dec 2013.
Reply
Thanks given by:
#15
(07-09-2015, 10:56 PM)svk Wrote: Can you use these?
http://www.greenwood-tools.co.uk/shopscr45.html

That would work but shipping would be prohibitive. Thanks for posting the link though. Someone over on that side of the pond may find it useful.

Ed
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)