Latest Delivery

[Mayhem]

I had expect this in response Rob:

[RobWilson]

Ha ha ha mint ,  I want one Darren    , I NEED a link to that , pleeeeeeeeeeeeeeease  !




Rob

[Mayhem]

http://cdn.stripersonline.com/8/8d/200x2...oticon.gif

[RobWilson]

Cheers Darren   




Rob 

[Sunset Machine]

Laughing myself silly here..

[Highpower]

Quiz: What is wrong with this picture? (I'll even thrown in a subtle hint...)  

   

   

[EdK]

I spotted it right away Willie. Did you put the old one back in or did you receive the incorrect bearings?

Ed

[Sunset Machine]

You have a big hole where the seal goes, exposing the marbles.

I finally had to change belt speeds on my mill/drill and found that some darn mice built a nest and peed all over the bearing. Apparently it's SEALED.

[Highpower]

(02-07-2016, 11:28 AM)EdK Wrote: I spotted it right away Willie. Did you put the old one back in or did you receive the incorrect bearings?  

Ed

I just wanted to get a picture of the inside of the drive housing before I started cleaning it out. All of the black crud in there is finely shredded v-belt material. Had the mill for several years now and I can't believe those bearings haven't crashed and burned. Not a drop of oil or grease to be found in them. They have been running dry the entire time.

I hadn't pulled the shaft out yet when I took the pic though.

I did get the correct bearings (sort of). I ordered Timken bearings. I got boxes that say Timken on them. The bearings inside are marked Fafnir. (Japan)

But they are the correct size, with double seals, so that is what I'm using.

[PixMan]

Either are very high quality bearings.

Avoid certain offshore makes though.