Laminated Step Blocks

[DaveH]

Tom
Good stuff

DaveH

[dallen]

nice thing about them is that I can make em with out my busted mill

[stevec]

DA, with my busted shaper and your busted mill maybe we should start a web site for disfunctional machine tools?

[Rickabilly]

(09-19-2012, 01:38 PM)dallen Wrote: nice thing about them is that I can make em with out my busted mill

But do you need laminated step blocks if your milling machine is busted?

Just kidding
regards
Rick

[dallen]

(09-20-2012, 10:42 AM)Rickabilly Wrote:

(09-19-2012, 01:38 PM)dallen Wrote: nice thing about them is that I can make em with out my busted mill

But do you need laminated step blocks if your milling machine is busted?

Just kidding
regards
Rick

could of used them years ago on the drill press but wasn't smart enough to figure out how to make em

and like someone said they could be used to take up slack in the vise on the saw for really short stuff

[dallen]

(09-20-2012, 07:43 AM)stevec Wrote: DA, with my busted shaper and your busted mill maybe we should start a web site for disfunctional machine tools?

Steve I got a 5 X 8 band saw we can add to the collection, can't have a dysfunctional machine shop without a Horizontal Band Saw now can we

[stevec]

W'ere on! What a sad success!

[dallen]

I got another one for the pile a 16 inch Cincinnati Shaper that has the shaft bores all wallowed out from lack of lube, and the cross feed for the table is all busted up. and I'm not to sure about the electric motor as its an old three phase that some one hung a static converter on that scares me to just look at it, much less than think about putting power to it.

[Wawoodman]

I'll contribute the arbor press. It works fine, but it's buried so deep I can't get there to use it...

[Rickabilly]

(09-20-2012, 03:04 PM)dallen Wrote: I got another one for the pile a 16 inch Cincinnati Shaper that has the shaft bores all wallowed out from lack of lube, and the cross feed for the table is all busted up. and I'm not to sure about the electric motor as its an old three phase that some one hung a static converter on that scares me to just look at it, much less than think about putting power to it.

At least you've got a machine to fix, so many guys out there are trying to find shapers and even considering building from scratch, fixing these machines is a whole lot more efficient that trying to build one and invariably you will end up with a better tool at the end, the big leap is always that first step and then deciding where to stop, that is full restoration or just fix the faults that are preventing use.
I know how daunting it can be starting a big repair but unless you give it a go ...

and we do have a great resource here with so many experienced machine repairers.

Regards
Rick