Old Wolf Bench Grinder
#11
(09-10-2012, 03:59 PM)EdK Wrote:
(09-10-2012, 03:57 PM)doubleboost Wrote:
(09-10-2012, 03:55 PM)EdK Wrote: Anyone else not seeing the images in post #5?

Ed

Working hear ED
John

Thanks John. I was hoping that would be the case. My internet service has been very flaky today.

OK, now I can see them. That grinder turned out real nice John. The paint job is superb. Thumbsup

Ed

Hi
Ed
Not bad for a quick wire brush and a coat of floor paint
John
Reply
Thanks given by:
#12
well dun john ups mell was suposd to drop me a lenth of box for you o well its dun gnaw
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#13
Nice job, I'd love to test that oldie against the chi-town one I have, I'll bet it'd win, hands down
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#14
Nice work there John - might be a little too close to the mill but good work just the same Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:
#15
Thumbsup Looking sharp John!
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#16
(09-11-2012, 06:37 AM)Mayhem Wrote: Nice work there John - might be a little too close to the mill but good work just the same Big Grin

It is just standing there next to the mill
It will be going in to a corner by its self
John
Reply
Thanks given by:
#17
John,
A really nice job ThumbsupSmiley-signs107Worthy Nice to see you took the "badges" off Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#18
John, how wide is the wheel on the left?

That one looks like it came out of a grain mill! Big Grin

That is a proper job of restoring that tool to its former glory. Smiley-eatdrink004
Willie
Reply
Thanks given by:
#19
(09-11-2012, 03:56 PM)Highpower Wrote: John, how wide is the wheel on the left?

That one looks like it came out of a grain mill! Big Grin

That is a proper job of restoring that tool to its former glory. Smiley-eatdrink004

Hi
Willie
It must be at least 2 inches
It is great for high speed steel
I need a green wheel for the other end so i can grind carbide
John
Reply
Thanks given by:
#20
Nice work on the grinder John, I especially like the quality of welds you ran on the tool rests. Nice to see another piece of old machinery standing proudly in a shop.

M.L.Woy
ml_woy, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)