Todays Project - What did you do today?

[EdK]

(12-31-2016, 04:02 PM)krv3000 Wrote: my I ask wher did you by it from

+1

[TomG]

The link in my post will take you to Banggood.com, but I found it on Amazon for less. Just do a search for Astrolux S41.

Tom

[EdK]

(12-31-2016, 07:20 PM)TomG Wrote: The link in my post will take you to Banggood.com

Oops! Sorry about that. I didn't see the link. My bad.

Ed

[EdK]

I worked on getting the shelving over where my lathe and mill are. They were at the  other end of the basement. I got the tooling shelf all restocked but still need to tackle the raw materials shelf. The raw materials are spread all over the basement in piles and it all came off of that one shelf.  
Some pictures. I'm showing probably about 75% of the materials that came off of the shelf.

Tooling and stock shelves.

         

Raw material.

         

         


I got the rubber material cut out to fit around the vise on the mill table.

   

Ed

[wawoodman]

You, sir, have entirely too much time on your hands.

You need to come visit me!

[f350ca]

Must have been a big shelf.
Nice shelving unit, someday I keep telling myself I'll get organized.

[EdK]

(01-02-2017, 05:05 PM)f350ca Wrote: Must have been a big shelf.
Nice shelving unit, someday I keep telling myself I'll get organized.

It's not that big. It's 36" wide and 18" deep. I was surprised how much was on that shelf. This is it below. Just have some miscellaneous stuff on it now which will have to go elsewhere.

Ed

   

[f350ca]

Just in case global warming is real and we get an early spring I thought I better get a trailer built for the canoe. Another made from scrap project, had to buy "ouch" the wheels hitch and lights. 3 inch 1/8 wall square tube for the frame, weighs only 240 pounds. The fenders were the curved bottom section from a 200 gallon home furnace oil tank. When you run it through the ring roller it takes the original curve out. 

[Old Minger]

Blimey Greg, your shop is bigger than my house!


Cheers
John

[DaveH]

(12-31-2016, 01:10 PM)TomG Wrote: I've been pretty fascinated with the advancements in flashlights lately, ....................................................................
Tom

     
Well I supose it is a bit "up" on the candle       
 
DaveH