Todays Project - What did you do today?
   
   
   
   
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by: aRM
Nice job. Did you get a "but its not purple" response?
Hunting American dentists since 2015.
Reply
Thanks given by:
(12-13-2016, 06:39 PM)Mayhem Wrote:
(12-13-2016, 12:56 PM)f350ca Wrote: Was just chain yanking Darren, have thought about one, how quick will they clean up a batch or rust nuts and bolts? Seams most of my raw material is rusty.

With the green pyramids (there are heavier duty grey pyramids available) and metal wash added, ....
Darren,
"metal wash" ... what exactly is this?
Thanks,
Arvid
Reply
Thanks given by:
http://www.eastwood.com/metal-wash-7-oz.html
Hunting American dentists since 2015.
Reply
Thanks given by: EdK , arvidj
(12-15-2016, 07:11 AM)Mayhem Wrote: Nice job. Did you get a "but its not purple" response?

No, I got a 'Have you really been out here all this time making that' response.
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:
I feel your pain Pete, I feel your pain...
Hunting American dentists since 2015.
Reply
Thanks given by:
(12-15-2016, 05:46 PM)Mayhem Wrote: http://www.eastwood.com/metal-wash-7-oz.html

Anyone have a current Eastwood discount code or coupon?

Ed,
 
If I order one do you want me to order one for you also? It's $16 but it is $6 to ship it. To ship two is only $2 more. And I can deliver it to where you work so ...

Arvid
Reply
Thanks given by:
(12-16-2016, 07:46 PM)arvidj Wrote:
(12-15-2016, 05:46 PM)Mayhem Wrote: http://www.eastwood.com/metal-wash-7-oz.html

Anyone have a current Eastwood discount code or coupon?

Ed,
 
If I order one do you want me to order one for you also? It's $16 but it is $6 to ship it. To ship two is only $2 more. And I can deliver it to where you work so ...

Arvid

That would be wonderful Arvid. Thumbsup

Ed
Reply
Thanks given by:
Threw some .303 charging clips in the tumbler today.

Before.
   

I usually put in half of the media and then drop the parts in on top before putting a teaspoon of metal wash in.
   

The rest of the media goes in and you can see the bowl is only about half full.
   

Total media is 7lb
   

After about six hours.  As you can see there are still some rough areas, so these could have stayed in a bit longer but I needed to pull them.
   

These will get oiled now and they should come out nicely.
Hunting American dentists since 2015.
Reply
Thanks given by:
(12-18-2016, 07:14 AM)Mayhem Wrote: I usually put in half of the media and then drop the parts in on top before putting a teaspoon of metal wash in.

Darren,

It looks like you put the metal wash in dry rather than mixing it with water [per the instructions]. Do you add any water at any point in the process or is it completely dry?

Arvid
Reply
Thanks given by:




Users browsing this thread: 165 Guest(s)