04-21-2013, 07:25 AM
Nice work with there in using the carbide drill Greg. I was at a meeting in Poland, so haven't been on much this past week.
Hunting American dentists since 2015.
|
Todays Project - What did you do today?
|
 
04-21-2013, 03:41 PM
Much gnashing of teeth today, 1,340 to be exact.
Decided to make some Myford 33 / 34 screwcutting gears for metric screwcutting on the imperial gearbox models. Gert was out of stock and giving me some grief.
John S., Nottingham, England.
04-21-2013, 04:10 PM
The third one down on the left looks a bit rough
 John 
04-21-2013, 05:56 PM
(04-19-2013, 09:07 AM)f350ca Wrote: Just an idle threat to prompt people to get posting. Nice weather means lawn work. Machining takes a backseat to honey-do lists.
Full of ideas, but slow to produce parts
04-21-2013, 06:26 PM
04-21-2013, 08:11 PM
The weather is keeping me in the shop too.
A quick repair on two tractor hubs. The two part seals broke loose from the hubs and wore them bad. Set up here to bore the hub to 4.000 then pressed a sleeve made from 4 inch od pipe, and rebored to fit the seals. Forgot to get a photo of the finished product. ![[Image: IMG_0568.jpg]](https://lh4.googleusercontent.com/-N5XmN6_zR4E/UXSNE-EYs8I/AAAAAAAABPo/v6RS3D-mewY/s1280/IMG_0568.jpg)
Free advice is worth exactly what you payed for it.
Greg 
04-21-2013, 10:39 PM
Making an engine hoist attachment for a $20 engine stand. The single nose wheel will, of course, be replaced with a crossbar and two casters. The arm will telescope so that it doesn't extend past the front wheels when it's in a lower position. Since the hoist is only for motorcycle engines, the hand winch will be sufficient.
Mike
If you can't get one, make one. Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
04-22-2013, 05:18 AM
(04-21-2013, 08:11 PM)f350ca Wrote: The weather is keeping me in the shop too. That's a serious boring bar you're using there. Ed |
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 50 Guest(s)