My little fab job
#1
Went camping for the week of the 4th, but needed to fix up some new steps for the camper first. I had some folding steps but by them self they were to short, so I went to the scrap been and got started.
           
First some brackets welded to the bumper for mounting to.
       
Next some risers to weld a step to and hang the folding steps from.
       
Sorry didn't get pics of the forming of the step but with no metal brake, it was a sharp steel table edge some heat, clamps, a piece of angle iron and a hammer.Sweat
[attachment=2340] [attachment=2341]    
[attachment=2343] [attachment=2344]
I then drilled some holes in the step to spot weld it to the risers.
[attachment=2345] [attachment=2346]
Now I have a set of steps for the camper that are safe and easy to use.
[attachment=2347]        
       
The best part is it all comes off with four bolts!
[attachment=2352]

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#2
Ok so I have no idea where my pics went???
       
       
       
       

And now you have the rest of the story!

I'm painting this week.

Jerry.Popcorn


Attached Files Thumbnail(s)
   
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#3
Nice job on forming that channel by hand Jerry! Thumbsup

How come you didn't use diamond plate for that top step? 17428

Willie
Willie
Reply
Thanks given by:
#4
(07-09-2012, 09:48 PM)Highpower Wrote: Nice job on forming that channel by hand Jerry! Thumbsup

How come you didn't use diamond plate for that top step? 17428

Willie

Willie,
Just used what was on hand, I will ad sand as I paint for a nonslip surface!Big Grin

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#5
What? No diamond plate on hand??? 17428

Sacrilege!!! Big Grin Big Grin Big Grin

Willie
Willie
Reply
Thanks given by:
#6
Jerry,

Looks good Smiley-signs107
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#7
a job well dun Thumbsup
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#8
Anybody else notice the perfectly executed plug welds? Worthy
Willie
Reply
Thanks given by:
#9
Nice work Jerry. Now you just have to move the door 6" to the left :)
Hunting American dentists since 2015.
Reply
Thanks given by:
#10
Nice job
Great to use material you have to handSmiley-signs107
I always seem to get sand in my paintSlapheadSlaphead
John
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)