07-08-2012, 06:57 PM
Very cool John,
Jerry.
Jerry.
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
|
Steam Engine Base Pattern
|
 
07-09-2012, 03:18 AM
you is geting ther john
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
07-09-2012, 03:51 AM
John,
A tidy job   DaveH 
07-09-2012, 04:23 AM
Now you will need a step ladder!
Nice work John.
Hunting American dentists since 2015.
07-09-2012, 03:47 PM
Hi
Lads Got the new melting pot finished Made up a couple of flasks (moulding boxes) Should be able to cast it this week end ![[Image: P7090051.jpg]](http://i261.photobucket.com/albums/ii63/john970s0/P7090051.jpg) ![[Image: P7090045.jpg]](http://i261.photobucket.com/albums/ii63/john970s0/P7090045.jpg) ![[Image: P7090049.jpg]](http://i261.photobucket.com/albums/ii63/john970s0/P7090049.jpg) ![[Image: P7090048.jpg]](http://i261.photobucket.com/albums/ii63/john970s0/P7090048.jpg) John 
07-09-2012, 04:14 PM
This is going to be interesting to watch.
 Ed
07-09-2012, 04:28 PM
John,
This is going to be fun, DaveH
07-09-2012, 07:54 PM
I'm all eyes John,
 Jerry.
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
07-10-2012, 04:51 AM
i may have a casting job for you john well not so much as casting more in the making of a pattern the band saw is missing the blade guide i don't have any pics of this bit but its the bit that holds two blocks ether side of the blade i may need something casting up
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
07-10-2012, 03:06 PM
That would be no problem at all Bob
John |
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 13 Guest(s)