|
P&W 1830 Radial in 1/6 scale.
|
03-28-2013, 09:47 PM
That's good, Bill. We can all breath again. The worst part is always the moment it takes to realize, "Yes, I do have to make a new one."
Mike
If you can't get one, make one. Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
03-29-2013, 12:34 PM
Thanx Hawk. Gents, it was a long haul but we have a completed crankcase.
"Billy G" 
03-29-2013, 08:22 PM
thats a lot of work you got there in your hand Bill, hell of a job.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
03-29-2013, 08:37 PM
Well done Bill - that must be a relief!
Hunting American dentists since 2015.
03-30-2013, 02:32 PM
Great piece of work Billy
   DaveH
04-07-2013, 01:37 PM
It has grown too large to safely handle during construction. This is the full crankcase length of 9 inches.
"Billy G" 
04-20-2013, 12:25 PM
The wife had an abdominal operation and I have been unable to get to the shop for a while.
OK, this is the humble beginnings of the custom intake manifold. "Billy G"
04-21-2013, 04:56 AM
Look after the little lady Bill - we'll be here waiting patiently for future progress...
Hunting American dentists since 2015.
04-21-2013, 06:53 AM
Will do Darren. She is getting about now so things have eased a little.
Here the brass binder is in place. When I bore the hole open for the carb I will have the binder locked in position to shape it also. "Billy G" |
|
« Next Oldest | Next Newest »
|
