Storage Building
#41
(07-16-2012, 07:29 PM)f350ca Wrote: Still too hot here for this cowboy, but managed to get the trusses built. Now to stand them up. Going to be interesting, I don't have an end wall to easily brace the first one to.
Ahh, Now I've played this game before,
the first truss goes up in the middle! rather than bracing the top of the truss to an end as you normally would when building a roof, what you do is knock a 2x4 into the ground directly below that first middle truss and bind the 1st truss to this upright, after the ends of the truss are secured to the beams at each end that first truss will be very secure, and you can brace the following trusses to it easily.

I hope this helps.
Best Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:
#42
Greg,
How about welding a temporary support to one of the sea cans? Smile
Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#43
If you're not to worried about affecting corrosion resistance or future value of the "sea cans" I'd weld that support on and leave it there, why not?
or even through bolt a simple bracket and brace to that, to seal it later just put a silicone covered bolt through the hole!

Best regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:
#44
All great suggestions, but I just got brave and nailed the bottom of the truss to the blocking and hoped the first two didn't fall over till I could brace them to each other. Slow work off the scaffolding (home made by the way) over the open section but have 1/3 of them up at the end of the day. Was getting dark hence the poor phone photo quality.

[Image: IMG_0084.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#45
Wow Greg, that is actually looking pretty good, My Dad had planned to do something similsr before he passed away and I tried to talk him out of it assuming it'd look pretty rough and very "improvised" but it looks quite respectable now that the trusses are going up, I suppose they take away the "Boxy" look.
Best Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:
#46
Nice work. To be honest, I was expecting a flat roof, not a gabled one. I guess geographical location has a lot to do with that though. So where are the hot tub and the bar going Greg?
Hunting American dentists since 2015.
Reply
Thanks given by:
#47
Greg,
Ooow that does look good Smiley-signs107
DaveH
Reply
Thanks given by:
#48
i think i need him to billed me a new workshop
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#49
A thought just crossed my mind (short trip, right? Rolleyes ), if you haven't already, plan on putting some gutters across both the front and back of the roof. You'll really want to get that water away from the building.

-Ron
11" South Bend lathe - Wells-Index 860C mill - 16" Queen City Shaper
Reply
Thanks given by:
#50
Looking great!! Always changes things a lot when one finally gets the trusses up.

Is this going to be strapped and a metal roof?
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)