Band Saw Light
#11
yep...stopped over at the parking lot sale yesterday and grabbed one. It is a nice lite. May have to get a couple more for working on/under the car etc.
I think its a nice feature that once the light is on for a few seconds...you dont have to remember to press the switch three times to turn it off.
Retired old guy finally living the dream and enjoying life to the fullest!!!
Reply
Thanks given by:
#12
(08-18-2024, 08:29 AM)rubes Wrote: I think its a nice feature that once the light is on for a few seconds...you dont have to remember to press the switch three times to turn it off.

Smiley-signs009

I also like the way the switch on the HF light illuminates green/red to give you an indication of the battery state of charge while you are using it.

The LED magnifying glass I recently bought has to be cycled through the stages in order to turn it off. I find it annoying when I accidentally go past "off" and have to go all the way round again.   Slaphead
Willie
Reply
Thanks given by:
#13
(08-17-2024, 01:37 PM)EdK Wrote: I have these that are stuck on both sides of my mill column. Plenty bright for me.

Magnetic Mount Lights

Ed

Those are the ones I use. Have them things stuck everywhere. They're also the only ones that showed the correct color when taking a picture with artificial light.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
#14
(08-17-2024, 11:12 AM)rubes Wrote: I have a similar one, with the same goose neck, on my mill. the goose neck is so limp it does not hold position.
Although, now that I think about it, it could be due to the fact I have the base mounted such that the goose neck comes out horizontal. that is the area that will not stay put and sags.

Mine does the same thing.  I was just down in the shop, and after trying to adjust it, only to have it slowly droop out of position, I moved it.  Now it's at the top of the column on the control box.  Unfortunately, the box is plastic, so it won't "stick" with the magnet.  My solution was to make a steel plate taped to the box with 3M VHB tape.

I removed the stupid people warning label, don't tell OSHA.
Full of ideas, but slow to produce parts
Reply
Thanks given by:




Users browsing this thread: 5 Guest(s)