metal cleaners
#31
(05-06-2012, 06:48 PM)stevec Wrote: Rob, do you put treakle on your waffles?


Don't like waffles 17428 but i do use treakle as a core binder Big Grin

Rob
Reply
Thanks given by:
#32
Hay guys kinda like this.Smiley-dancenanaSmiley-eatdrink004

       

       

       

This is real time some stuff still cooken

the skillet took about 3 hrs, my charger is set at 40 amps

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#33
Hi Jerry,

If you increase the number of sacrificial electrodes, you will get quicker results. I made a ring out of some weld mesh (non-galvinsed) to line the inside of my tub.

I do like the use of the foam to ensure the work piece doesn't short out.

Also - just a note to other - don't use a stainless steel electrode as the chromium is released during electrolysis. Most of the stuff I have read thus far points to the best results being gained using rusty electrodes, which is good because I had plenty of rusty old weld mesh :)
Hunting American dentists since 2015.
Reply
Thanks given by:
#34
Hi Jerry,
Nicely done Smiley-signs107
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#35
Smiley-signs009

Don't forget to season that pan again right away, unless you just want to continue practicing on de-rusting it again....

Big GrinBig GrinBig Grin
Willie
Reply
Thanks given by:
#36
Hi WillieRotfl,

OOOOOOO yes they will get properly seasoned.Smiley-eatdrink004

The pans were given to me by my sister in law, she thought they were junk
and hoped maybe I could use them in one of my projects.
When my wife saw them her eyes lit up and asked can we clean them up for camping, and thus a project is born.Big GrinBig Grin

Thanks for the tip MayhemThumbsup


Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#37
They came out looking great Jerry Thumbsup

Rob
Reply
Thanks given by:
#38
Thanks to all for your comments and suggestions,Smiley-eatdrink004

this has been a fun experiment with a practical application.Thumbsup

I will be perfecting my new found metal derusting tool! Drool

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 9 Guest(s)