MetalworkingFun Forum › Machining › General Shop Stuff v
pressure washer problems

Thread Modes
pressure washer problems
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#1
07-30-2020, 07:12 PM
My pressure washer will no longer siphon the cleaning solution into the pump.  I've never torn down one of these pumps and was hoping there is a way to back flush it or something to get it going again.
Reply
Thanks given by:
Vinny Online
Another Whipping Boy
*******
Posts: 2,620
Threads: 100
Joined: Dec 2014
Location: Michigan
#2
07-31-2020, 11:01 PM
The only suggestions my manual gives are: siphon hose not connected to the tank; siphon hose plugged or cracked; high pressure nozzle installed. You've prolly already ruled out all three.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Website
Reply
Thanks given by:
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
The following 1 user Likes Dr Stan's post:
Vinny (08-01-2020)
#3
08-01-2020, 08:27 AM
A search revealed some YouTube vids that point to replacing the siphon mechanism.  I'll go ahead and order one for my unit and swap it out before I use it again.  Looks like a very simple repair.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)