MetalworkingFun Forum › Machining › How-To's v
Mill a circle

Thread Modes
Mill a circle
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
The following 2 users Like Dr Stan's post:
Highpower (10-19-2019), EdK (10-20-2019)
#11
10-19-2019, 04:36 PM
(10-19-2019, 03:39 PM)Paulc Wrote: You guys are quite persuasive Big Grin .
Finally broke down and ordered a rotary table.

Now just have to figure out how to use it!  Blush

https://www.youtube.com/watch?v=oQtO0VELAi8
Reply
Thanks given by:
Highpower Offline
JAFO
******
Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
The following 1 user Likes Highpower's post:
Dr Stan (10-20-2019)
#12
10-19-2019, 08:00 PM
(10-19-2019, 03:25 PM)Dr Stan Wrote: Just added a HT furnace to my "need" list. Big Grin

Rotfl

By the way Stan, what goes around comes around. Watching Joe's videos cost me dearly in the last couple of weeks. I now own not one, but two vintage magnetic dial indicator holders (US General and a Craftsman) because of that guy. I also got one of his rotary table alignment pins in the mail today. Big Grin
Willie
Reply
Thanks given by:




Users browsing this thread: 4 Guest(s)