Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
Finally getting some time to get the drill press set up. Need to get some No 4 Morse taper sleeves to reduce down to my drill bits. I see hardened and ground as well as soft sleeves offered. Think the sleeves I have for the lathe are hardened, but also have some old #3 ones which are dinged up, guessing they're soft.
Which should I get and why.
Thanks
Free advice is worth exactly what you payed for it.
Greg
Posts: 13
Threads: 3
Joined: May 2017
Location: Kentucky
I would think i would want hardened ones ,if you like me and all ways dinging and dropping them. would be very easy to get a high spot ,and you know what that means. thats when i get a slip and then i tear up the inside taper.
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
(07-13-2017, 10:11 PM)Pumpjack Wrote: I would think i would want hardened ones ,if you like me and all ways dinging and dropping them. would be very easy to get a high spot ,and you know what that means. thats when i get a slip and then i tear up the inside taper.
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
KBC tools had a sale last week, so I ordered the hardened ones. The drill press uses the tang to ensure you don't get slip. The Hardinge lathe on the other hand doesn't use the tang.
Free advice is worth exactly what you payed for it.
Greg
