Planer Blade Grinder
#21
Its getting to be a real problem. 
When I finished the wood processor I had to clear out a bay in the shed. That meant finding a home for the lumber that was there. That meant resawing it and getting it planed and putting it on the ceiling of the veranda. Still haven't found a space for the riding mower that the processor displaced.
On the subject of the veranda, Julia just finished one of the stained glass pieces for above the doors.

[Image: djMZTt3IEI6dl_Dzy-9jyYugg1EGklpAVG7P4jVt...2-h1224-no]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#22
Julia does nice work.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by: f350ca
#23
The blade grinder suddenly made sense with that last photo.
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:
#24
The picture of the window Pete.
Have the height adjustment pretty much made. Still need to make a fancier bolt.
[Image: mP_RNudYnoAT0mIp923DcTPjJQWMn3OKMVsScpot...2-h1224-no]

[Image: jtB6vkG12aklAWEZdKD7YOHou2QyB88dGOYQ64ck...2-h1224-no]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#25
Nice work Greg!

Ed
Reply
Thanks given by: f350ca
#26
(12-09-2016, 07:35 PM)f350ca Wrote: The picture of the window Pete.

Not so much. That one reminded me of the early eighties when my mother did a leadlighting course and went mad with it for a couple of years. That is a nice window.
The blade grinder is a nicely designed and built tool, as always.
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by: f350ca
#27
Is that a linear bearing? How do they hold up in a grinding environment?
Reply
Thanks given by:
#28
Im wondering too Al. Think I'll connect an air line and make it an air bearing, well sort of. If I feed 5 or 10 psi air into the housing while grinding Im hoping it will flush the dust away before it gets in.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#29
Just looking back over this thread Greg and having a closer look at the shaper clamp setup, did you have to drill and tap holes in the end of the table, or were there already holes there?
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:
#30
They were there Pete. 1/2 inch coarse thread, just had to make the plate with slotted holes similar to the plates on the mag table for the grinder.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:




Users browsing this thread: 5 Guest(s)