Changes To The Franken-Drill Adapter Plate
#1
Today I finally got around to finishing up the DP adapter plate. I finally got the plate cut out for the Franken-Drill column, then drilled the plate to hold 4 different DP vises.

About 30-35 years ago, I broke my left wrist, using a drill press, so the desire to secure the object being drilled, is very vivid in my memory. I have one of these DP adapter plates on every DP I own. With the adjustability the plate gives me, the variety of DP vises on hand, the X, Y and Z movement of the table, I can drill just about any hole, with some accuracy and safety.


1 - the plate, with the cut out
2 - the plate on the Franken-Drill
3 - the small Craftsman angle vise
4 - the normally used Palmgren DP vise, pushed all the way in
5 - pulled all the way out


Attached Files Thumbnail(s)
                   
jack
Reply
Thanks given by:
#2
On to the Mark 4 version, I revamped the plate again, I cut the ears off the back of the plate and rewelded the plate to close up the slots on the back edge. After thinking about the plate, I couldn't think of why I actually cut the notch in the back of the plate, leaving the ears, as long as the table stayed centered, not an issue, but the ears couls cause a limitation on side travel, so they had to go.


Attached Files Thumbnail(s)
       
jack
Reply
Thanks given by:




Users browsing this thread: