MetalworkingFun Forum › Machining › General Metalworking Discussion v
Precision ball bearings?

Thread Modes
Precision ball bearings?
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#31
02-19-2016, 01:55 PM
(02-05-2016, 01:08 PM)Sunset Machine Wrote: I used an engine hoist to flip mine over in order to clean the ways, piece of cake.

Mine is at least twice as thick and I wouldn't trust my engine hoist with it.
Reply
Thanks given by:
Sunset Machine Offline
Junior
****
Posts: 716
Threads: 32
Joined: Apr 2012
Location: Washington, USA
#32
02-19-2016, 10:34 PM
And twice as long. I had a notion that a pair of them might get that table back where it belongs. $25/day rentals here.
Reply
Thanks given by:




Users browsing this thread: 4 Guest(s)