|
Setting Up My PM935 Mill
|
09-09-2016, 09:44 PM
(09-09-2016, 07:18 PM)f350ca Wrote: Is that saying the saddle is moving Ed? Either that or my original setup was wimpy. I'll rerun it but using the Noga instead of the cheap one and see if the results are different. I found a video on YouTube that shows how to check to see if the gibs are too loose. I'll run that test also. I trammed the mill this evening so I'm close to letting the chips fly. Ed
09-10-2016, 12:41 PM
The best I could get it is about .00175 across the 22" of travel. I'm not sure if that's good or not but I'm done with fiddling with it and I'm going to go ahead and start using it.
Ed
09-10-2016, 04:25 PM
It's starting to look like a mill and the shop is finally coming back together. And yes, that's twine holding on that temporary control box on the mill.
Ed 
09-10-2016, 07:24 PM
Looking good Ed
 won't be long now   DaveH
a child of the 60's and 50's and a bit of the 40's
Thanks given by: EdK
09-10-2016, 08:51 PM
Why the twine?
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique
09-10-2016, 09:16 PM
he was out of bailing wire
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
09-10-2016, 09:40 PM
09-11-2016, 08:37 AM
(09-10-2016, 04:25 PM)EdK Wrote: It's starting to look like a mill and the shop is finally coming back together. And yes, that's twine holding on that temporary control box on the mill. So thats whats a milling machine's base looks like, I haven't seen mine in years. Mine is covered with adjustable angle tables, chunks of round and square stock and misc stuff. DAMN!! thet floor is SO clean, I would not be alb;e to sleep at night......................... 
jack
|
|
« Next Oldest | Next Newest »
|
