MetalworkingFun Forum › Machinery › Milling Machines v
In the Market

Thread Modes
In the Market
Thumb Offline
Sophmore
***
Posts: 63
Threads: 10
Joined: Jun 2015
Location: Medford, Or
#21
06-17-2015, 06:32 PM
Any suggestions on the best way to get all that grease off?
Reply
Thanks given by:
Hopefuldave Offline
Sophmore
***
Posts: 168
Threads: 6
Joined: Mar 2012
Location: Surrey, England
#22
06-17-2015, 07:36 PM
Kerosene and lots and lots of rag....
Rules are for the obedience of fools, and the guidance of wise men...
(Douglas Bader)
Reply
Thanks given by:
arvidj Offline
Junior
****
Posts: 735
Threads: 34
Joined: Feb 2012
Location: Minneapolis, MN
#23
06-17-2015, 07:38 PM
(06-17-2015, 06:32 PM)Thumb Wrote: Any suggestions on the best way to get all that grease off?

I think I used WD-40 to clean my stuff. That and lots of blue paper towels. 
Reply
Thanks given by:
Thumb Offline
Sophmore
***
Posts: 63
Threads: 10
Joined: Jun 2015
Location: Medford, Or
#24
06-17-2015, 07:54 PM
Well, I have about 5 gallons of kerosine and lots of paper towels so maybe that will work. I'm moving my table
saw outside so maybe I can take some of that grease and put it on the table to keep it from rusting too. BTW, anyone interested in a 1960 Craftsman table saw that works? Big Grin
Reply
Thanks given by:
arvidj Offline
Junior
****
Posts: 735
Threads: 34
Joined: Feb 2012
Location: Minneapolis, MN
#25
06-17-2015, 08:14 PM
I'm sure kerosene will also get the job done. The aroma in the shop will be different that with WD-40 but the end result will be the same. Good luck!!
Reply
Thanks given by:
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#26
06-17-2015, 10:24 PM
WD40 is mostly kerosine, with some nice smelling light oil added.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)